However, Pentair will not connect using my phone or my computer software. The above ScreenLogic Interface Kits (520502) require a 4-wire, 22-gauge wiring connection from the IntelliTouch or EasyTouch Controller Load Center COM port to the protocol adapter … Hello Folks, Up for sale is this used Pentair Screenlogic Interface Protocol Adapter. Before connecting the cable to the adapter, first determine the length of cable required for the connection. The name is displayed on the ScreenLogic Connect dialog as shown below: System is working fine via the outdoor control panel. Screen Logic interface unit has power light, and the rx/tx lights indicate they are operating. Existing ScreenLogic Protocol Adapter (Pentair Brick: xx-xx-xx) ScreenLogic Video & Lighting Protocol Adapter AC Power adapter DB9M / RJ45 PCS Light switch(s) found around the home LAN COM 1 ScreenLogic Wireless Router Note: PSC light switches are compatible with incondescent light bulbs only. The Video & Lighting Protocol adapter system name is identified on the screen as: Pentair: xx-xx-xx (where xx-xx-xx are the last six (6) digits of the unit’s serial number which can be found on a sticker on the adapter).
You canunplug and plug back in the wireless router to reset it. Connect to the Protocol adapter: Proceed to “Connect to the Protocol Adapter,” page 24. ScreenLogic Video & Lighting Protocol Adapter Name. the issue maybe within connecting to the protocol adapter. You need to run a wire from the Pentair control panel to the RS-485 device. If you have the Screenlogic protocol Adapter, this is the same wire and you can potentially extend it or run a new one alongside it to the panel. This allows control of IntelliTouch pool and spa systems via local wifi signal or remotely via cellular network. Download the Protocol Adapter update tool (available for PC and Mac): Also, how do I reset my Pentair protocol adapter? 5.
: Connect To The Protocol Adapter Connect to the Protocol Adapter The IntelliTouch ScreenLogic Protocol adapter is connected to the Personality board located in the Load Center or Power Center via a four-wire cable. That way, the Hello Folks, Up for sale is this used Pentair Screenlogic Interface Protocol Adapter. Pentair iPhone/ iPad/ iPod Touch Interface Kit - Includes Protocol Interface Adapter that connects to your wireless router then to existing Desktop or Laptop PC. This item has been tested with full system and is working on 03/10/21. This goes onto the Comm connector blocks inside the pentair panel.
0 kommentar(er)
